Knowledge Base
HOME » KNOWLEDGE BASE » FORUM

SX1262 NRESET

Hi,

We link SX1262 NRESET pin to microcontroller. Microcontroller pin do not have internal Pullup or Pulldown. I would like to know if we need to add hardware PULL UP, in order to maintain a voltage level on this pin when we do not used it?

Thank you in advance for your response,
Regards
Avatar
Hi,

According to Table 8-3 of the datasheet, "Digital Pads configuration for each Chip mode", the NRESET pad has a 50 kOhms pull-up inside.

Best regards