documentation
HOME » DOCUMENTATION » TECHNICAL DOCUMENTS » LoRa Edge™ Tracker Reference Design User Guide v1 » Introduction

Introduction

Welcome to the LoRa Edge™ Tracker Reference Design User Guide. In this guide, we introduce you to the Semtech LoRa Edge Tracker Reference Design V1.0 and explain how to set it up with a network server and the associated mobile application, LoRa Edge Config.

The reference design consists of the following components:

  • LoRa Basics™ Modem-E, built with the LR1110 chip

  • STM32WB55CG processor

  • Accelerometer sensor

  • Hall Effect sensor

  • Four antennas:

    • Sub-GHz antenna

    • 2.4 GHz antenna

    • GNSS PCB antenna

    • GNSS Patch antenna

LoRa Edge Tracker Reference Design V1.0 (Bottom)

Figure 1: LoRa Edge Tracker Reference Design V1.0 (Bottom)

Picture of the PCB (Top)

Figure 2: LoRa Edge Tracker Reference Design V1.0 (Top)

LoRa Edge™ Tracker Reference Design V1.0 (Full)

Figure 3: LoRa Edge™ Tracker Reference Design V1.0 (Full)

LoRa Edge™ Tracker Reference Design V1.0 (Enclosure)

Figure 4: LoRa Edge™ Tracker Reference Design V1.0 (Enclosure)

Next
« RETURN TO TECHNICAL DOCUMENTS